New Year Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 70special

Acme Packet AP0-001 Acme Packet Certification Certification Exams Boot camp & Braindump Exam Practice Test

Page: 1 / 14
Total 140 questions

Acme Packet Certification Certification Exams Boot camp & Braindump Questions and Answers

Testing Engine

  • Product Type: Testing Engine
$37.5  $124.99

PDF Study Guide

  • Product Type: PDF Study Guide
$33  $109.99
Question 1

What sip-config option will limit the number of routes that the Net-Net 4000 attempts after prioritizing all local policies for a new inbound SIP call?

Options:

A.

max-routes

B.

route-limit

C.

next-hops

D.

hop-limit

Question 2

The __________ parameter allows for multiple network interfaces to be bound to a single physical interface.

Options:

A.

sub-port-id

B.

vlan-id

C.

hip-ip-addr

D.

vlan

Question 3

Examine the output below from the network interface configuration.

When the Net-Net 4000 does not get an ARP response from the device configured as its gateway in the configured retry time period, it will____________.

Options:

A.

send traffic to the device configured in the sec-gateway field

B.

decrement its health score to 50 which may result in a failover to the standby

C.

use the Virtual Router Redundancy Protocol (VRRP) to determine a new default gateway

D.

use the Virtual Router Redundancy Protocol (VRRP) to the host(s) instead of the primary gateway

Question 4

Which one of the following statements about the Net-Net 4250 is FALSE?

Options:

A.

There are two fans, each with configurable speed control.

B.

The fan module is field upgradeable.

C.

The fan speed is automatically adjusted to the appropriate level based on the current operational status and system environment.

D.

The fan module can move the air a total of 30 cubic feet per minute.

Question 5

__________ are stored in NVRAM.

Options:

A.

Logs

B.

CDRs

C.

Boot parameters

D.

Backup configurations

Question 6

You have changed a parameter in the realm-config element and have issued the done command. The change has now been committed to the __________ configuration.

Options:

A.

saved

B.

active

C.

edited

D.

running

Question 7

Examine below the output from the show sipd invite command.

Of the 600 Busy Everywhere messages sent by the Net-Net 4000, how many in the last 140 seconds did not originate from a downstream device?

Options:

A.

4

B.

161

C.

13

D.

0

Question 8

To enable the Net-Net 4000 to provide next hop signaling load balancing, which two of the following licenses must be installed?

Options:

A.

session agent group

B.

load balancing

C.

routing

D.

local policy

Question 9

The boot parameters, passwords and licensing information are stored in __________.

Options:

A.

SDRAM

B.

NVRAM

C.

Flash

D.

CAM

Question 10

A(n) __________ is an association between a globally unique SIP or SIPS URI and the user agent's contact address. This association is written by the registrar server to a database where it can be used by a proxy in the local domain.

Options:

A.

location record

B.

AOR

C.

binding

D.

public address

Question 11

When the Adaptive Hosted NAT Traversal feature is enabled, the Net-Net 4000 will ______________.

Options:

A.

send PING messages to dynamically learn the binding time of a endpoint behind a NAT device

B.

send OPTIONS methods at a defined incrementing period to dynamically see if an endpoint behind a NAT device is still reachable

C.

create bindings for the Addresses of Record of endpoints that are not behind a NAT

D.

create bindings for the Addresses of Record of endpoints that are behind a NAT

Question 12

When SIP sessions are terminated and re-originated as they flow through the Net-Net 4000, the ____________ is rewritten to force all session related media to be routed through Net-Net 4000.

Options:

A.

Via

B.

From

C.

SDP

D.

Contact

Question 13

__________ is the percentage of a Net-Net 4000 peer advertisement time for the other peer in the high availability (HA) cluster to wait before considering the peer out of service.

Options:

A.

200%

B.

percent-drift

C.

310%

D.

standard-deviation-score

Question 14

Which two of the following statements about realms are TRUE?

Options:

A.

You must have a minimum of three realms in any configuration as one realm must be designated as the home realm.

B.

All endpoints within a realm must reside within the same subnet as the Net-Net 4000.

C.

Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP-interface per realm.

D.

You can associate multiple realms with a single network interface.

Question 15

In a(n) __________ exchange, a Master Slave Determination message is an example of a type of message that might be exchanged during the media setup portion of the call.

Options:

A.

RAS

B.

ISDN

C.

H.245

D.

H.225

Question 16

What sip-config option will suppress the inclusion of a registration cache cookie in the Contact header of messages forwarded?

Options:

A.

reg-mode=no cache

B.

reg-cache-mode=none

C.

reg-mode=none

D.

reg-cache-mode=no cache

Question 17

__________ cookies are included by Sipd when it receives messages that are originally sourced from a device other then the configured External Proxy Address.

Options:

A.

Call-Leg

B.

Dialog

C.

Session

D.

SIP-NAT

Question 18

When two associated H323 stacks in different realms have the gatekeeper parameter defined, which one of the following statements is TRUE?

Options:

A.

The Net-Net 4000 will proxy LRQ and LCF messages from one gatekeeper to the other and the TCP connection for H.225.0 will be established afterwards.

B.

The Net-Net 4000 will respond locally to the LRQ with a LCF, and upon receiving the SETUP on the ingress leg, will open the TCP connection on the egress leg to send the SETUP.

C.

It is not possible to have two associated H323 stacks when both have gatekeepers defined.

D.

Registrations will be forwarded from one Gatekeeper to the other using unique RRQ messages.

Question 19

You have copied a new Net-Net OS to the Net-Net 4000 and changed the boot parameters according to the display below. On reboot, the Net-Net 4000 is in a boot loop.

training1# check-space-remaining boot boot:

0/29702144 bytes (0%) remaining

training1# configure terminal

training1(configure)# bootparam

'.' = clear field; '-' = go to previous field; q = quit

boot device : wancom0

processor number : 0

host name :

file name : /tffs0/sd200p23.gz /tffs0/sd400q10.gz

inet on ethernet (e) : 10.0.3.11:ffff0000

inet on backplane (b) :

host inet (h) : 10.0.3.1

gateway inet (g) : 10.0.0.1

user (u) : anonymous

ftp password (pw) (blank = use rsh) : anonymous

flags (f) : 0x80008

target name (tn) : training1

startup script (s) :

other (o) :

NOTE: These changed parameters will not go into effect until reboot. Also, be aware that some boot parameters may also be changed through PHY and Network Interface Configurations.

training1(configure)# exit

training1# reboot force

Based on the information above, which three of the following scenarios could be the cause of the boot loop?

Options:

A.

You did not copy the Net-Net OS file into the /boot directory.

B.

The Net-Net OS file was truncated while being copied to the /boot directory due to lack of file space.

C.

You mistyped the name of the Net-Net OS file in the file name property of the boot parameters.

D.

The Net-Net 4000 was reset using the reboot force command without saving and activating the configuration changes first.

Question 20

When configuring the allow-anonymous parameter in the SIP port element, a value of __________ may be configured to allow access only from user agents who have previously registered through the Net-Net 4000 or who are configured as session agents.

Options:

A.

registered

B.

agents-only

C.

realm-prefix

D.

prev-registered

Question 21

The Net-Net 4000 will release media between SIP endpoints that are located in the same realm when the ____________parameter is set to____________.

Options:

A.

msm-network disabled

B.

mm-in-realm disabled

C.

mm-in-network enabled

D.

mm-in-realm enabled

Page: 1 / 14
Total 140 questions