Which SC Series array feature simplifies iSCSI connectivity and allows access to all ports through redirection?
A customer wants to add an SC420 and an SC200 to a SC7020 storage array. What is the recommended approach to adding the new enclosures?
What is the correct sequence of steps to present a volume to an ESXi host?
A customer is using an SC8000 array with three chained SC220 expansion enclosures on a single card. They need to expand its capacity by adding an SC280 enclosure. How should the new expansion enclosure be connected using a minimum number of chains?
After the implementation of a DR site with Synchronous replication all applications were up and running fine. The restore points were saved and validated; DR was predefined and successfully tested. Sometime later, one of the applications became unresponsive and initial troubleshooting points to Storage/Volume as the root cause.
Concerning the Replication to the DR site, what could be happening?
Which datapage size options are available for SC Series arrays?
Which operating system runs the Dell Storage Manager (DSM) as a virtual appliance?
Refer to the Exhibit.
A customer has asked you to perform a port failover test to demonstrate system resiliency. What is needed to complete this task?
How many SC420 enclosures can be supported by the SC7020 controller?
Based on documented best practices, which options may need to be modified on a server QLogic HBA?
Which best practices should be followed when using iSCSI to connect SC Series arrays and hosts?
What is the maximum number of disks that can be supported by an SC4020 running SCOS 6.6.4 or later?
Which redundancy option is available for drives on an SC7020 storage array?
Refer to the exhibit.
When scanning Fibre Channel on a QLogic HBA what information can be obtained?
What information should be considered when planning for storage performance requirements?
You are implementing a front-end connection in Legacy Port Mode on an SC4020 in a SAN with two iSCSI switches. What is the minimum number of port(s), per switch, that can be used by each controller?
How much memory does the Dell Storage Manager (DSM) Virtual Appliance require to manage seven SC Series arrays?
What is the maximum memory supported on a single SC9000 controller?
During the addition of an SCv360 enclosure to a SCv3020 the PCle SAS card is used for connectivity. The enclosure is NOT recognized by the system, why?
Why would the Key Management Server (KMS) Settings page appear during installation?
You recently added a second Storage Center to your network. Both systems were added to DSM, and you can ping the iSCSI ports of the remote system. You are planning to replicate between your two systems, but you cannot get the Replication Wizard to launch.
What item is missing?
What is the maximum number of Fault Domains on a SCv3000 Storage Center using SAS front-end?
