An administrator needs to expand a cluster based on AHV and running on Nutanix G5 hardware with a new Nutanix G7 system. The cluster is running AOS 5.10 but the operation fails when expanding the cluster. AOS is running on the new system. There are no issues discovering the node.
Why is the operation failing?
An administrator is deploying Nutanix Files 3.5 and needs to configure the sizing of the FSVMs for an increased number of concurrent SMB connections over the default 750.
What should the administrator do?
For several days, an administrator notices the following alerts:
• CVM NIC Speed Low Warning Alerts
• Warning Alerts of CVM NIC not performing at optimal speed
• CVM is disconnected from the network Critical Alert
• Network Visualization page shows excessive dropped packets on CVM/Host
Which steps should be taken to determine which problem should be addressed first?
An administrator needs to make sure an RF2 cluster can survive a complete rack failure without negatively effecting workload performance. The current cluster configuration consists of the following:
• 30 nodes: distributed 10 nodes per rack across three 42U rack
• Each nodes is configured with 40TB usable storage all flash (Cluster Total 1.2 PB Usable)
• Current cluster utilization is 900TB storage
Which configuration changes should be made to make sure that the cluster meets the requirements?
An organization is planning an upgrade to AOS 5.15 and wants to understand which cluster products and/or services are supported for physical traffic isolation.
Which Nutanix component supports its network traffic being isolated onto its own virtual network?
Refer to the exhibit.
An administrator receive the warning massages shown in the exhibit while validating cluster conversion from EXSi to AHV.
What should the administrator do to address this warning in v Center Server?
An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:
What is causing this issue?
A guest VM is reported to have poor storage performance. It has an I/O profile of 80% read. 20% write, and the HDDs form more than 50% of the read source.
What should an administrator do to resolve this issue?
Refer to the exhibit.
What is the purpose of eth2 on the CVMs?
While creating an image placement policy on the organizations AOS 5.15-based Nutanix cluster, the administrator wants to ensure there are no restrictions on using the selected images on clusters outside of the identified set.
What type of Policy Enforcement must the administrator choose?
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?
A customer has two mission-critical applications and needs to have them backed up to a remote location. The remote location is connected using a leased line and has an average latency of 7 ms.
Which Nutanix technology will provide the shortest RPO possible?
An administrator is supporting a business critical environment and deploys metro availability to achieve a zero data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read throughput.
Which change must be made to deploy the workload successfully on this cluster?
An administrator responsible for a VDI environment needs to investigate reports of slow logins. The administrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count on all of the VDI VMs.
What are two impacts on the cluster? (Choose two.)
Refer to the exhibit.
An administrator logs in to Prism and sees the status shown in the exhibit within the Hardware Diagram section.
What should the administrator do?
A customer needs a DR solution designed around the following requirements:
• There are 8 ms of latency between Sites A and B
• The administrator needs the shortest RPO/RTO possible
• Application consistent snapshots are required
• Use of Nutanix VSS
Which Data Protection Method should be used?
